Galvan 25 Digital Single Channel Iontophoresis Device

Technical Custom

Galvan 25 Iontophoresis Device Usage

1. Up to half the water containers fill with tap water (so as not to overflow when hand or foot is dipped)
2. Plug the device into the socket .(220 volts )
3. ON-OFF button (on the back of the device)
4. Polarity right or left It is not important in the first application. However, continue with the right and left in the second and subsequent applications. Do not touch the polarity button while applying.
5. Reset the dose adjustment button
6. Water your hands or feet put them in their containers.
7. With or without pedals Pedal input is on the back of the device (Pedal is for starting current by stepping on it in hand application. If you have an assistant, this is not necessary.) NOTE: There is no pedal in two-channel devices.
8. Dose adjustment button to the right Turn it slowly towards the right. Increase it until you feel tingling. The point where the tingling starts is the most suitable setting for you. (This figure may vary according to the user's body resistance.)
9. Treatment time given by the physician 10-40 minutes is recommended in the literature.
10. step on the footswitch along the length of
11. When the time is up, take your foot off the pedal Pull. Set the dose adjustment knob to zero.
12. Turn off the device and drain the water.

After Use

1. Dry the metal electrodes and water containers after use.< /li>
2. Do not reuse the same water .

NOTE: Use the maximum If you do not get enough results even though you use it in doses, you can add very little salt to the negative pole water container with black plug (table salt).

< /p>

TOTAL TREATMENT TIME 3 A WEEK (21 DAYS) IS RECOMMENDED. TIME CAN BE SHORTENED OR EXTENDED WHEN Sweating is regulated.